Jump to content

Connect interface line out to Stage box


khachai44

Preporučeni Komentari

Hi,

I'd like to connect RME UCX line out to PA.
The mixer is far away so I have to connect to stage box which has XLR inputs that go to Mixer Mic input.


RME UCX line out specs:
• Output: 6.3 mm TRS jack, servo-balanced
• Output impedance: 75 Ohm
• Output level switchable Hi Gain, +4 dBu, -10 dBV
• Output level at 0 dBFS @ Hi Gain: +19 dBu
• Output level at 0 dBFS @ +4 dBu: +13 dBu
• Output level at 0 dBFS @ -10 dBV: +2 dBV

I am not sure about the PA Mixer specs or even if it has Pad on inputs.

I am sending full stereo mix, so don't want any artifacts like tonal shifts or loss of dynamics.

What is the best way to connect this ?
Is simply lowering output level going to work ?
Do I need a DI Box ?
Link to comment
Podeli na ovim sajtovima

  • Odgovora 2
  • Kreirano pre
  • Zadnji odgovor pre

Aktivni članovi u ovoj temi

Popularni dani

Aktivni članovi u ovoj temi

source is having enough cojones to drive long trace

 

but you really need to connect that line (high level) to appropriate input in PA Mix , to preserve dynamics

worse case would be using custom balanced attenuator box or balanced to balanced DI Box , but you can still do that

 

in any case - long trace must stay balanced

Link to comment
Podeli na ovim sajtovima

Kreiraj nalog ili se prijavi da daš komentar

Potrebno je da budeš član DiyAudio.rs-a da bi ostavio komentar

Kreiraj nalog

Prijavite se za novi nalog na DiyAudio.rs zajednici. Jednostavno je!

Registruj novi nalog

Prijavi se

Već imaš nalog? Prijavi se ovde

Prijavi se odmah
  • Članovi koji sada čitaju   0 članova

    • Nema registrovanih članova koji gledaju ovu stranicu
×
×
  • Kreiraj novo...